WEEK 14 : THESIS WRITING

-

For this week, I'm taking a break from the busy day to clear my mind. It a bit stressful to continue the preparation. So I decide to chill out for a week and focus on subject, lab report and other assignment.



The progress for this week is to complete the draft of the thesis paper as the results of the research is done. The result of the finding is put into a GRAPH as the results of the RESPIRATION RATE is taken from the several subject from the testing.




After including all of the results from the finding of the testing, the analysis of the results is written. The thesis paper is then completed with the final chapter is also written with the correct format is used for it. After the thesis paper is finalized with my supervisor, the technical paper is proceeded to be written.




Comments

Post a Comment

Popular posts from this blog

WEEK 6 : (FYP2) DESIGN SCHEMATIC DIAGRAM OF THE CIRCUIT

-
Image
 For this week, I'm going to design the circuit diagram for my project. This circuit consist of several component including the microcontroller NodeMCU.   So, I'm using the fritzing software to design the circuit diagram on breadboard. I'm using A0 as the Input for the Force Sensitivity Resistor. For LED I'm using the D1 and D3 pin for the output. The push button is use as the external reset button and is connected to the RESET pin. The switch is use to turn on and off the circuit. So how this device work. when we are breathing, there will be a change in resistance with respect to the force of the thoracic. When breathing occurs, there will be increase in the force. This increase in force will reduce the resistance in FSR and this reduction in resistance will allow conductance and this conduction is counted as one breath. This is the process involved in measuring the heart rate.
Read more