WEEK 7 : (FYP2)TEST THE SENSOR OF CIRCUIT ON THE BREADBOARD

-

After doing the schematic diagram of the circuit last week, so its time to test the circuit connection on the breadboard.


So here is the circuit I construct to test the functionality and the connection of the circuit.





The picture above show that the circuit work after it was power up by 3.7 Volt Lithium ion battery.

The test pen and multimeter is use to check the connection between the components.

 


Comments

Post a Comment

Popular posts from this blog

WEEK 15 : FINAL TOUCH UP AND PROJECT PROGRESS

-
Image
In this week, I'm doing the final touch on my project. By using the enclosure that I bought I put the circuit I solder in the enclosure. The enclosure is in compact size so it will be easy to carry around by the user. All the wire is arrange carefully pack in the enclosure. We are required to attend the meeting with the supervisor to update the progress on the project. After presenting madam Hasmiza ask me to collect several data from the subject and make a line chart to analyse the data obtain. The average of respiration rate was recorded to compare the rate between sitting and standing position.
Read more

WEEK 14 : THESIS WRITING

-
Image
For this week, I'm taking a break from the busy day to clear my mind. It a bit stressful to continue the preparation. So I decide to chill out for a week and focus on subject, lab report and other assignment. The progress for this week is to complete the draft of the thesis paper as the results of the research is done. The result of the finding is put into a GRAPH as the results of the RESPIRATION RATE is taken from the several subject from the testing. After including all of the results from the finding of the testing, the analysis of the results is written. The thesis paper is then completed with the final chapter is also written with the correct format is used for it. After the thesis paper is finalized with my supervisor, the technical paper is proceeded to be written.
Read more

WEEK 12 :(FYP2) TECHNICAL REPORT FYP BRIEFING

-
Image
There was a briefing on a technical paper this week. The goal of this technical document is to provide a 5-page summary of the FYP report. It will be graded by industry professionals rather than the FYP supervisor. It can also boost a student's worth during a job interview in the future by demonstrating to the industry that UniKL BMI students can generate a high-quality technical paper that can be displayed in public. It simply needs to be 5 pages long, and it doesn't need to be long and complicated. We can ask from the supervisors for advice on how to write a good technical paper if they need it for this technical paper. It will be graded along with the FYP report, but it will be graded separately.
Read more