WEEK 17 - BLOG SUBMISSION

-

 



As I writing this blog I can keep track on my FYP 1 progress for every week. 

Comments

Post a Comment

Popular posts from this blog

WEEK 15 : FINAL TOUCH UP AND PROJECT PROGRESS

-
Image
In this week, I'm doing the final touch on my project. By using the enclosure that I bought I put the circuit I solder in the enclosure. The enclosure is in compact size so it will be easy to carry around by the user. All the wire is arrange carefully pack in the enclosure. We are required to attend the meeting with the supervisor to update the progress on the project. After presenting madam Hasmiza ask me to collect several data from the subject and make a line chart to analyse the data obtain. The average of respiration rate was recorded to compare the rate between sitting and standing position.
Read more

Week 3: (FYP 2) COMPONENTS RESEARCH AND FINDING

-
Image
Activity: Hardware Follow Up  During the third week, I'm  using my time to revise back the component I  use in the propose project to be bought for the FYP2. After trying to use the existing item to make the system. I discovered  that the Arduino Uno R3 is at the disadvantage  because of the less pin provided on the board to be connected to the ESP8266 Wi-Fi module and the Bluetooth    module. Therefore I  have decide  to change  the microcontroller  board to the NodeMCU. This is because  the NodeMCU  already have an imbedded  Wi-Fi module on the board  with a lot of GPIO pin.\ Below is the component that have been research and need to be used for this project. a)     Monitoring System 1-     NodeMCU ESP8266 (1 unit) 2-     Force Sensitivity Resistor (1 unit) 3-     TP4056 Battery Charger (1 unit) 4-     Momentary SPST Push Button ...
Read more

WEEK 7 : (FYP2)TEST THE SENSOR OF CIRCUIT ON THE BREADBOARD

-
Image
After doing the schematic diagram of the circuit last week, so its time to test the circuit connection on the breadboard. So here is the circuit I construct to test the functionality and the connection of the circuit. The picture above show that the circuit work after it was power up by 3.7 Volt Lithium ion battery. The test pen and multimeter is use to check the connection between the components.  
Read more