WEEK 10: (FYP2) MEETING WITH SUPERVISOR

-

In this week, the meeting is was conducted with the supervisor online via M. Teams. The content of the meeting is about the progress of the project. 


Dr. Hasmiza recommend that using the stripboard for the circuit. Stripboard is one of the commonly-used types of prototyping board. These boards are intended for permanently assembling one-off circuits, especially prototypes. The board is made from insulating material, usually a resin-bonded plastic or fibreglass. It make the circuit more steady with the help of soldering.


Comments

Post a Comment

Popular posts from this blog

WEEK 6 : (FYP2) DESIGN SCHEMATIC DIAGRAM OF THE CIRCUIT

-
Image
 For this week, I'm going to design the circuit diagram for my project. This circuit consist of several component including the microcontroller NodeMCU.   So, I'm using the fritzing software to design the circuit diagram on breadboard. I'm using A0 as the Input for the Force Sensitivity Resistor. For LED I'm using the D1 and D3 pin for the output. The push button is use as the external reset button and is connected to the RESET pin. The switch is use to turn on and off the circuit. So how this device work. when we are breathing, there will be a change in resistance with respect to the force of the thoracic. When breathing occurs, there will be increase in the force. This increase in force will reduce the resistance in FSR and this reduction in resistance will allow conductance and this conduction is counted as one breath. This is the process involved in measuring the heart rate.
Read more