WEEK 5 : (FYP2) PROJECT DESIGN

-

 For this week, I'm using the paint sofware and the microsoft word to design the project. 




Comments

Post a Comment

Popular posts from this blog

WEEK 15 : FINAL TOUCH UP AND PROJECT PROGRESS

-
Image
In this week, I'm doing the final touch on my project. By using the enclosure that I bought I put the circuit I solder in the enclosure. The enclosure is in compact size so it will be easy to carry around by the user. All the wire is arrange carefully pack in the enclosure. We are required to attend the meeting with the supervisor to update the progress on the project. After presenting madam Hasmiza ask me to collect several data from the subject and make a line chart to analyse the data obtain. The average of respiration rate was recorded to compare the rate between sitting and standing position.
Read more

WEEK 7 : (FYP2)TEST THE SENSOR OF CIRCUIT ON THE BREADBOARD

-
Image
After doing the schematic diagram of the circuit last week, so its time to test the circuit connection on the breadboard. So here is the circuit I construct to test the functionality and the connection of the circuit. The picture above show that the circuit work after it was power up by 3.7 Volt Lithium ion battery. The test pen and multimeter is use to check the connection between the components.  
Read more

WEEK 6 : (FYP2) DESIGN SCHEMATIC DIAGRAM OF THE CIRCUIT

-
Image
 For this week, I'm going to design the circuit diagram for my project. This circuit consist of several component including the microcontroller NodeMCU.   So, I'm using the fritzing software to design the circuit diagram on breadboard. I'm using A0 as the Input for the Force Sensitivity Resistor. For LED I'm using the D1 and D3 pin for the output. The push button is use as the external reset button and is connected to the RESET pin. The switch is use to turn on and off the circuit. So how this device work. when we are breathing, there will be a change in resistance with respect to the force of the thoracic. When breathing occurs, there will be increase in the force. This increase in force will reduce the resistance in FSR and this reduction in resistance will allow conductance and this conduction is counted as one breath. This is the process involved in measuring the heart rate.
Read more